To enhance the construction process of the grating, it is essential to conduct quality checks of the grating during the construction phase. This will enable the identification of any quality issues during the grating's construction, allowing the construction team to rectify any problems promptly. Through the identification and sorting out of construction quality problems, all construction units can identify possible process quality challenges, and adjust them accordingly while also devising relevant preventive measures. The goal is to ensure the grating construction quality is up to standard.
To prevent overload damage to the grid plate, it is important to take preventive measures. This includes making sure that when stacking materials and equipment on the platform, the lower part is leveled with square wooden pads and that the stacked items do not exceed the design load.
2. Without taking protective measures, the equipment hoisting wire rope directly passes through the grid plate, causing damage to the grid plate. Preventive measures: If there is a grating plate at the hoisting and hanging point of the equipment, protective measures must be taken. If necessary, the grating plate can be temporarily removed, and the installation can be resumed after the hoisting.
To avoid misaligned installation bars on the grille plate, it is recommended to use the same batch of products when installing in the same position. Before installation, check the size of the grille plate to ensure that it meets the requirements. If the size is not suitable, it is advisable to use it on a small area and draw a fixing line before soldering. After soldering, adjust the alignment of the installation bars accordingly. This preventive measure will ensure a consistent and accurate installation of the grille plate.
4. The grille plate is not cut as required, and the pipeline construction grille plate is not neatly cut with flame, which affects the beauty. Precautionary measures: When the pipe installation needs to pass through the grating plate, first determine the cutting position and mark according to the position of the pipe and the outer diameter of the pipe. Use a cutting machine to cut as much as possible. If flame cutting is used, it should be polished and cleaned in time before the construction of the pipe. After the opening of the grille plate, the edge should be sealed. The pipeline passes through the platform grille plate without edge-sealing treatment or the edge-sealing treatment is not aesthetically pleasing. Precautionary measures: The opening of the grid plate through the platform should be drawn according to the pipe, the outer diameter of the pipe, and the position of the grid plate after the expansion and displacement of the pipe. Use a cutting machine to cut along the drawn line position, and seal the edges in time after cutting. Pipes can be installed after the edge has been sealed.
5. No protective measures are taken during cutting. Preventive measures: iron plates must be laid below the platform grid plate during welding and cutting operations to prevent damage to the galvanized layer of the grid plate. After the zinc layer is damaged, it should be repaired and sprayed in time.
https://www.greaty-grating.com/
